hydraulic and pneumatic ball valve installation steps to Collection

Web Design And Seo For www.china-webdesign.com

hydraulic adapters - China Manufacturer

Thank you for inquiry my hydraulic adapters, Tel : +86-0574-88461212, E-mail:ph@ph-fitting.com

http://www.ph-fitting.com/Adapter/

         1), removing the flange end on both sides of the protective cover, to wash clean the valve is fully open state.

 
2), signal (electric or gas) system test prior to installation should be required (to prevent vibration affect performance due to transportation), after passing the on-line installation (wiring by electric actuator circuit diagram).

 
3) preparation and pipe connections shall be washed and cleared of residual impurities in the clean pipe (these substances may damage the valve seat and the ball).

 
4), during installation, please do not use the part of the valve actuator as the lifting of the lifting point, in order to avoid damage to the implementing agencies and accessories. .

 
5), this type valve should be installed in the horizontal direction or vertical direction of the pipeline.

 
6), the pipeline can not install near the falls or to withstand the external phenomenon, pipe support or supports can be used to eliminate the pipeline deviate from.

 
7), and pipe connections, please use the specified torque cross-l ocking flange connecting bolts.